Engineering, 11.07.2021 23:50 darkghostmist

) A hydraulically operated multidisk plate clutch has an effective disk outer diameter of 160 mm and an inner diameter of d mm. There are six sliding planes. The coefficient of friction (f) is 0.20 and the maximum pressure (Pa) is 900 kPa. (a) Using the uniform wear model, estimate the axial force.
(b) Calculate the inner diameter of the plates for maximum torque and determine the maximum Torque
(hint: differentiate torque T with respect to inner diameter of d).

) A hydraulically operated multidisk plate clutch has an effective disk outer diameter of 160 mm an

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

) A hydraulically operated multidisk plate clutch has an effective disk outer diameter of 160 mm and...

Questions