Engineering, 14.07.2021 15:50 errinbaker4683

A spur pinion and gear pair is used to transmit a power of 25 kW. The teeth number of pinion is 18. The distance between the centers of the pinion and the gear is 144 mm. The sped ratio is 3, the
pressure angle is 20o and the face width is 50 mm. The rotational speed of pinion is 1200 rev/min. The
pinion and the gear material are through hardened Grade-2 with a hardness of 300 Brinell. The quality
standard number Qv is 7 and installation is open gearing quality. The power source and the driven
machine are subjected to medium and moderate shocks, respectively. Find the AGMA bending and
contact stresses and the corresponding factors of safety for a pinion life of 107 cycles and a reliability of
0.99.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

You know the right answer?

A spur pinion and gear pair is used to transmit a power of 25 kW. The teeth number of pinion is 18....

Questions