subject
Engineering, 19.07.2021 23:00 alarconanais07

A wastewater treatment plant discharges 2.19 m3/sec into a stream with a flowrate of 10 cubic meters per second. The ultimate BOD concentration in the treated wastewater is 30 mg/L, and 3 mg/L in the river. DO in the river is 6.5 mg/L and the DO in the treated wastewater is 4 mg/L. Saturation for DO at the ambient temperature is 8.2 mg/L. At the current temperature the deoxygenation coefficient, kd, is 0.61 day 1, while the reaeration coefficient kr = 0.76 day 1. The rivers flow velocity is 0.41 meters per second. How long does it take to reach the critical time in the river? a. 35.4 hours
b. 9.6 hours
c. 1.0 days
d. 1.7 days

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
You know the right answer?
A wastewater treatment plant discharges 2.19 m3/sec into a stream with a flowrate of 10 cubic meters...
Questions
question
Advanced Placement (AP), 30.07.2019 05:30
Questions on the website: 13722361