subject
Engineering, 27.07.2021 05:00 amahar4000

: Mạch điện hình 3 có : R = R ; C = C , = 10nF ; R = 100k2 ; R = 300k 2 a . Mạch đã thỏa mãn điều kiện dao động chưa , vì sao ? b . Nếu thỏa mãn , tìm R , R , để mạch có tần số cộng hưởng là 2,5 kHz .


: Mạch điện hình 3 có : R = R ; C = C , = 10nF ; R = 100k2 ; R = 300k 2 a . Mạch đã thỏa mãn điều k

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
You know the right answer?
: Mạch điện hình 3 có : R = R ; C = C , = 10nF ; R = 100k2 ; R = 300k 2 a . Mạch đã thỏa mãn điều ki...
Questions
question
Mathematics, 30.08.2020 02:01
question
Social Studies, 30.08.2020 02:01
question
Physics, 30.08.2020 02:01
question
History, 30.08.2020 02:01
question
History, 30.08.2020 02:01
Questions on the website: 13722359