subject
Engineering, 02.08.2021 18:10 annie901

If a scope's sweep time control is set for 5 mS and the displayed signal covers four divisions to make one full waveform, what is the total elapsed time of one cycle? A. 40mS
B. 20mS
C. 5mS
D. 10mS​

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
If a scope's sweep time control is set for 5 mS and the displayed signal covers four divisions to ma...
Questions
question
Chemistry, 07.10.2020 05:01
question
Mathematics, 07.10.2020 06:01
question
Social Studies, 07.10.2020 06:01
question
Mathematics, 07.10.2020 06:01
question
Social Studies, 07.10.2020 06:01
question
English, 07.10.2020 06:01
question
English, 07.10.2020 06:01
Questions on the website: 13722360