Engineering, 06.08.2021 16:00 rusa25

A cylinder, 6 mm in diameter, has a length of 24 mm. One end of the cylinder is open while all other surfaces have external insulation. The inside of the cylinder is diffuse and gray having an emissivity of 0.8 and a uniform temperature of 1000 K. (a) Draw a sketch and state your assumptions
(b) Determine the radiant power leaving the open end of the cylinder.
(c) Calculate the effective emissivity of the cylinde.
(d) The length of the cylinder is decreased to 6mm, what is the effective emissivity of the cylinder?
(e) If the length of the cylinder is decreased further, do you expect an increase or decrease in the effective emissivity?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

A cylinder, 6 mm in diameter, has a length of 24 mm. One end of the cylinder is open while all other...

Questions