subject
Engineering, 07.08.2021 14:00 simonthang8

Xác định và phân tích các nhân tố giao tiếp trong ngữ liệu sau: - Bẩm cụ từ ngày cụ bắt đi ở tù, con lại sinh ra thích đi ở tù: bẩm có thế, con có dám nói gian thì trời tru đất diệt, bẩm quả đi ở tù sướng quá. Đi ở tù còn cơm để mà ăn, bây giờ về làng về nước, một thước cắm dùi cũng không có, chả làm gì nên ăn. Bẩm cụ, con lại đến kêu cụ cho con đi ở tù...
- Cụ bá quát, bắt đầu bao giờ cụ cũng quát để thử dây thần kinh của người.
Anh này lại say khướt rồi!
Hắn xông lại gần, đảo ngược mắt, giơ cái tay lên nửa chừng:
- Bẩm không ạ, bẩm thật là không say. Con đến xin cụ cho con đi ở tù, mà nếu không được thì... thì... thưa cụ...
- Hắn móc đủ mọi túi, để tìm một cái gì, hắn giơ ra: đó là một con dao nhỏ nhưng rất sắc. Hắn nghiến răng nói tiếp:
- Vâng, bẩm cụ không được thì con phải đâm chết dăm ba thằng rồi cụ bắt con giải huyện.
- Rồi hắn cúi xuống, tần mần gọt cạnh cái bàn lim. Cụ bá cười khanh khách – cụ vẫn tự phụ hơn đời ở cái cười Tào Tháo ấy, cụ đứng lên vỗ vai hắn mà bảo rằng:
- Anh bứa lắm. Nhưng này anh Chí ạ, anh muốn đâm người cũng không khó gì. Đội Tảo nó còn nợ tôi năm mươi đồng đấy, anh chịu khó đến đòi cho tôi, đòi được tự nhiên có vưởn...

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:20
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
You know the right answer?
Xác định và phân tích các nhân tố giao tiếp trong ngữ liệu sau: - Bẩm cụ từ ngày cụ bắt đi ở tù, co...
Questions
question
Mathematics, 16.02.2020 01:32
question
Mathematics, 16.02.2020 01:32
question
Mathematics, 16.02.2020 01:32
question
Mathematics, 16.02.2020 01:33
question
Mathematics, 16.02.2020 01:34
Questions on the website: 13722361