Engineering, 09.08.2021 20:40 smortandsons

Snowmobile track drive shaft The figure shows a drive shaft, supported in a snowmobile frame by bearings A and B, which is chain-driven by sprocket C. (The engine and transmission are above and forward of the shaft; hence, the 30° chain angle.) Track sprockets T1 and T2 drive the snowmobile track. Basic dimensions are given in the figure as well. Determine an appropriate design for the shaft, based on a maximum engine output of 20 kW at a vehicle speed of 72 km/h. Because the track and chain do not impose stringent deflection requirements and the bearings can be self-aligning if necessary, the preliminary design should be based on fatigue strength. - 2500 N) 300 Chain P1000N Track Chain Sprocket 100 diameter Track Track Sprockets a) Snowmobile Track sprocket 250 diameter (H) General arrangement B T2 55 Small gap or spring washer (c) Shaft layout

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

You know the right answer?

Snowmobile track drive shaft The figure shows a drive shaft, supported in a snowmobile frame by bear...

Questions