Consider the scenario where performance of two models (A and B) are measured on the same cross validation folds. To evaluate a hypothesis that the average performance of model A is better than the average performance of model B, what type of hypothesis test should you use? Unpaired, two-sided t-test

Paired, two-sided t-test

Paired, one-sided t-test

Unpaired, one-sided t-test

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m