Engineering, 01.09.2021 02:20 DeathFightervx
Which of the following is not permitted when cutting holes in I-joists?
A. Removing more than one of the manufacturer's knockouts.
B. Cutting more than one hole in the web
C. Holes 1 1/2" in diameter or larger/|
D. Holes within 1" of a bearing surface.
Answers: 1
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Which of the following is not permitted when cutting holes in I-joists?
A. Removing more than one...
Social Studies, 29.04.2021 05:40
Engineering, 29.04.2021 05:40
English, 29.04.2021 05:40
Mathematics, 29.04.2021 05:40
Mathematics, 29.04.2021 05:40
English, 29.04.2021 05:40
Biology, 29.04.2021 05:40
Mathematics, 29.04.2021 05:40
Mathematics, 29.04.2021 05:40
Mathematics, 29.04.2021 05:40
Computers and Technology, 29.04.2021 05:40
Mathematics, 29.04.2021 05:40