Engineering, 01.09.2021 16:40 yiikes4012

What is the answer of this question please tell me

dadada please please

Answers: 2

Show answers

Another question on Engineering

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

Engineering, 06.07.2019 05:10

Air contained in a piston-cylinder assembly undergoes a process from an bar. the initial pressure of 1 bar and temperature of 400 k to a final pressur initial volume of air is 0.2 m3. the process is described by pv- constant. assuming ideal gas behavior and neglecting kinetic and potential energy effects, determine the a)-mass of air, in kg b)-work for the process, in kj c)-heat transfer for the process, in kj pts

Answers: 1

Answer

Engineering, 06.07.2019 05:10

An ideal vapor-compression refrigeration cycle is employed to maintain a building temperature of 23°c when the outside temperature is 37°c. the cycle operates at steady state using ammonia as the working fluid. the mass flow rate of the refrigerant is 15 kg/min. the refrigerant enters the compressor at 1.5 bar and 10 °c. the condenser pressure is 20 bar and the temperature at the condenser exit is 45 °c. determine (a) the compressor power in kw. (b) the refrigeration capacity in tons. (c) the coefficient of performance. d) the maximum theoretical coefficient of performance.

Answers: 2

Answer

You know the right answer?

What is the answer of this question please tell me

dadada please please...

Questions