subject
Engineering, 02.09.2021 17:20 97seouls

The thermal conductivity of a sheet of rigid, extruded insulation is reported to be k=0.029W/m*K. The measured temperature difference across a 20-mm-thick sheet of the material is T1-T2=10degrees C. (a) What is the heat flux through a 2m x 2m sheet of the insulation?
(b) What is the rate of heat transfer through the sheet of insulation?
For part a,
q"=0.029W/m*K *((10)/0.020)=14.5W/m^2
For paft b,
qx=(HW)qx"=(2x2)*14.5W/m^2=58W
-Is the above soultions correct?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
question
Engineering, 04.07.2019 19:10
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
The thermal conductivity of a sheet of rigid, extruded insulation is reported to be k=0.029W/m*K. Th...
Questions
question
History, 13.01.2020 10:31
Questions on the website: 13722359