Engineering, 02.09.2021 21:20 rujirasri3620
A tensile test was performed on a metal specimen with a circular cross section. The diameter was measured to be 0.550 inch. Two marks were made along the length of the specimen and were measured to be 2.030 inches apart. This distance is defined as the gage length, and all length measurements are made between the two marks. The specimen was loaded to failure. Fracture occurred at a load of 28,500 pounds. The specimen was then reassembled, and the diameter and gage length were measured to be 0.430 inch and 2.300 inches. Determine the:
a. Ultimate tensile stress in ksi.
b. Elongation as a percentage.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
You know the right answer?
A tensile test was performed on a metal specimen with a circular cross section. The diameter was mea...
Questions
History, 24.07.2019 17:30
Biology, 24.07.2019 17:30
Social Studies, 24.07.2019 17:30
History, 24.07.2019 17:30
Biology, 24.07.2019 17:30
Social Studies, 24.07.2019 17:30
Biology, 24.07.2019 17:30
Biology, 24.07.2019 17:30
Social Studies, 24.07.2019 17:30
English, 24.07.2019 17:30
English, 24.07.2019 17:30
Social Studies, 24.07.2019 17:30
