Engineering, 05.09.2021 20:10 anrs14

5. A manufacturing company implemented a new production process to reduce defective fuses. From the old process, it was computed that at least 1 defect costs the company an average of
$6,500,000.00 per production run. After implementing the new process, suppose a large lot
contains 10% defective fuses and four fuses are randomly sampled from the lot.

a. Find the probability that at least one fuse in the sample of four is defective.

b. (Continuing from result in item a) in one production run of 500 eighty-unit lots, how
much would be the loss if the cost to manufacture one unit is 335.75?

c. How much is the difference from the old process? Did the new process effectively
reduce the company's losses?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 06.07.2019 04:30

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volume for a gas is much higher than the average volume for a liquid. d)-there is no difference.

Answers: 2

Answer

Engineering, 06.07.2019 05:30

Measuring the distance between two trees, you measure that there are 75.5 steps between the two trees. give an estimate of the unit of measurement of one step in meters and give an estimate of what you think its uncertainty is. give the distance that separates the trees in meters as well as feet/inches and round to the correct amount of significant digits. what would you say are the uncertainties for the these two distances

Answers: 3

Answer

Engineering, 11.07.2019 00:40

Aspherical balloon is filled with air, with an initial volume equal to 65.42 m meter equal to 5 m). air enters through an opening of area equal to 0.785 m^2 (diameterequa 1m) at a velocity of 3 m/s. the pressure and temperature of the air inside the system remain constant and are equal to the pressure and temperature of the air entering the system. determine how long it takes for the volume of the sphere to increase to 2571.14 m^2

Answers: 2

Answer

You know the right answer?

5. A manufacturing company implemented a new production process to reduce defective fuses. From th...

Questions