Engineering, 12.09.2021 18:10 markjiron2880
A capacitive sensor element can be used to measure air pressure in a pneumatic system. Use the attached datasheet to design an air pressure sensor. Your design must include everything from the primary sensing element (Protron capacitive pressure sensor) up to the input of a microcontroller responsible for digitizing the sensor output and processing it further. Your unique specifications are given below. Assume that you are sensors analog output is interpreted on a linear scale (e. g. 0V = 0.9 bar and 5V = 1.25 bar with a linear relationship for everything in between). Calculate the total error* of your sensor (including the error incurred during digitalization) and validate your design by means of simulation software.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
A capacitive sensor element can be used to measure air pressure in a pneumatic system. Use the attac...
Questions
Computers and Technology, 16.10.2019 00:10
English, 16.10.2019 00:10
Mathematics, 16.10.2019 00:10
Physics, 16.10.2019 00:10
Mathematics, 16.10.2019 00:10
Mathematics, 16.10.2019 00:10
