Engineering, 13.09.2021 23:50 Meirna
In an experiment there are 3 types of variables: 1) a control variable (does NOT change), 2) an independent variable (the thing that changes) and 3) a dependent variable (what are we measuring in the experiment?) In this engineering experiment, what would you list as the CONTROL (stays the same) variable? *
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
In an experiment there are 3 types of variables: 1) a control variable (does NOT change), 2) an inde...
Questions
Mathematics, 19.08.2019 21:20
History, 19.08.2019 21:20
English, 19.08.2019 21:20
History, 19.08.2019 21:20
English, 19.08.2019 21:20
Mathematics, 19.08.2019 21:20
History, 19.08.2019 21:20
