subject
Engineering, 16.09.2021 14:00 demarcuswiseman

Upon examination of an engine that will not start after a complete overhaul, the technician finds that both the intake and exhaust valves are open at the same time when the piston is 1" (2.34cm) past TDC on the intake stroke. Technician A says this phenomenon is valve overlap and could not be the cause of the engine not starting. Technician B says the camgear is not properly indexed with the crankgear. Which technician is correct? Technician A
Technician B
Both Technician A and B
Neither Technician A or B

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
Upon examination of an engine that will not start after a complete overhaul, the technician finds th...
Questions
question
Mathematics, 14.06.2021 01:00
question
Mathematics, 14.06.2021 01:00
Questions on the website: 13722360