Engineering, 21.09.2021 14:00 gothicleonardogal

1. Soil: Soil 2. Radial Lines: Radial Lines 3. Concentric Lines: Concentric Lines 4. Density Gradient Tube: Density Gradient Tube 5. Tempered Glass: Tempered Glass 6. Stress marks: Stress marks Column B a. any disintegrated surface material, both natural and artificial, that lies on or near the earth's surface b. glass fractures lines which form on the surface opposite that of the penetrating force c. glass tubes 6 to 10 mm in diameter and from 25 to 40 cm in length filled with layers of different densities. d. glass which as been tempered so as not to crack or slither in the fashion of normal glass e. white fracture lines which are observed microscopically on a cross section of glass f. glass fractures lines which form on the same side as the penetrating force

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

1. Soil: Soil 2. Radial Lines: Radial Lines 3. Concentric Lines: Concentric Lines 4. Density Gradien...

Questions