Engineering, 22.09.2021 14:00 mckayboyd1

6) Describe the differences between the troposphere and stratosphere. 7) What is the standard temperature lapse rate?

8) What is standard pressure in pounds per squire inch (psi) at sea level on a standard day?

9) Does atmospheric pressure decrease with an increase in altitude? Does it decrease proportionally?

10) Define and describe pressure altitude.

11) Define and describe density altitude. What effect does density altitude have on aircraft performance?

12) What three factors change air density?

13) How does humidity affect aircraft performance? Do performance charts account for humidity?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

You know the right answer?

6) Describe the differences between the troposphere and stratosphere. 7) What is the standard temp...

Questions