Engineering, 01.10.2021 03:40 tsimonej12
1. Engineering controls are the physical changes that employers make to the work environment or to equipment that make it safer to use.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
You know the right answer?
1. Engineering controls are the physical changes that employers make to the work environment or to e...
Questions
Mathematics, 23.02.2022 14:00
Mathematics, 23.02.2022 14:00
Advanced Placement (AP), 23.02.2022 14:00
SAT, 23.02.2022 14:00
Mathematics, 23.02.2022 14:00
Physics, 23.02.2022 14:00
Geography, 23.02.2022 14:00
SAT, 23.02.2022 14:00
