Engineering, 11.10.2021 06:00 yanelyportillo7

A sphere 30mm in diameter initially at 800K is quenched in large bath having a constant temperature of 320K with a convection heat transfer coefficient of 75W/m^2. K. The thermo-physical properties of the sphere material are rho = 400kg/m^3, c = 1600 J/kg. K, and k = 1.7W/m K. a) Sketch the temperature gradient in the sphere over time with temperature (y-axis) and radius (x-axis) showing several lines to represent the initial time, an intermediate time, and the temperature at after a long time has elapsed. Note the boundary conditions you assumed in the center of the sphere and the edge of the sphere and show them on your sketch b) Calculate the Biot number and determine the best solution path using a characteristic length of gamma _o. c) Calculate the time required for the surface of the sphere to reach 415K [seconds]. d) At the time found, determine the heat flux [W/m^2] from the surface of the sphere.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

You know the right answer?

A sphere 30mm in diameter initially at 800K is quenched in large bath having a constant temperature...

Questions