Engineering, 23.10.2021 05:10 scarletmartinez

You are assigned a task to design the Composite wall of a Curing Oven two layers of bricks and one ofinsulation (as shown in the figure). Heating is accomplished by an electric heater. Inside the oven there is a fanto homogenize the temperature ( T = X °C, h = 50 W/m2°C). Lab environmental condition are (T = 25 °C, h =(X/20) W/m2°C).(a) Calculate thickness of insulation (k = 0.015 W/m°C) to reduce heat transfer up to (100/2.5)%.(b) Calculate the temperature on the outer surface of the oven.(c) Calculate heat transfer from brick-1.(d) If it is assumed that the same heat transfer from all six sides, calculate the cost of electricity for threehour. (use 30 Rs/kw-h))

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2

Answers: 2

Answer

You know the right answer?

You are assigned a task to design the Composite wall of a Curing Oven two layers of bricks and one o...

Questions