Engineering, 23.10.2021 14:00 donnafranks2003

A temperature control system is designed to maintain the temperature at a constant value of 500 C inside an induction furnace.
126 Chapter 4
(a) The following test set of initial temperature measurements (once the furnace
temperature has reached steady state) is obtained: 507 502 520 500 492 485 499
495 497 500 516 501 489 503 490 481 504 511 499 512
Show that this is free of rogue data points and can therefore be used as a reference set against which to test future temperature measurements.
(b) The temperature is then measured at 10 min intervals and the following 20 measurements are obtained:
481 505 495 519 498 1015 508 477 500 526 501 488 502 492 464 503 499 510
515 497
Test whether there are any rogue measurements in this data set.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

A temperature control system is designed to maintain the temperature at a constant value of 500 C...

Questions