Engineering, 25.10.2021 07:30 savannahvargas512

Q9 : Assume the Following Process. Process Burst Time Priority Arrival Time
P1 16 3 0
P2 3 1 5
P3 5 5 8
P4 6 4 4
P5 11 2 6
For the set of processes directly above, draw a Gantt chart for the Round Robin
Scheduling Algorithm using. CS=0
a) For the set of processes directly above, draw a Gantt chart for the the Round
Robin Algorithm for a time quantum of q= 5 ms.
b) For the set of processes directly above, calculate the throughput for the
Round Robin Algorithm for a time quantum of 5 ms.
c) For the set of processes directly above, calculate the turnaround time for the
Round Robin Algorithm for a time quantum of 5 ms.
d) For the set of processes directly above, calculate the average turnaround
time for the Round Robin Algorithm for a time quantum of 5 ms.
e) For the set of processes directly above, calculate the waiting time for the
Round Robin Algorithm for a time quantum of 5 ms.
f) For the set of processes directly above, calculate the average waiting
time for the Round Robin Algorithm for a time quantum of 5 ms.
g) What will happen if the time quantum for the Round Robin Algorithm is too
small?
h) What will happen if the time quantum for the Round Robin Algorithm is too
large?
i) What is the CPU Utilization for the system?
Q 10: Repeat Q9 with CS=1

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

Q9 : Assume the Following Process. Process Burst Time Priority Arrival Time
P1 16 3 0
...

Questions