Engineering, 27.10.2021 08:30 lllmmmaaaooo

The wall designer recommends the use of rounded 3/8-inch nominal maximum aggregate size for this wall. The dry rodded unit weight for the coarse aggregate is 115 pcf with a specific gravity of 2.78. The moisturecontent for coarse aggregate is measured at 0.35% and the fine aggregate moisture content is 8.4%. The coarse and fine aggregates have absorption percentage of 1.1% and 1.4% respectively. The aggregate provider will be limited in fine aggregate supply, only providing aggregates with a fineness modulus of 2.70 with a specific gravity of 2.64. Cement will be provided by a local plant providing type I-II cement with a specific gravity of 3.15. No cementitious materials are available at this time. Air entraining admixture is needed for this interior wall. Required:
a. Provide the product name and type
b. Provide the manufacturer's recommended dosage (oz/lb of cement or mL/lb of cement)
c. Provide the dosage recommended for this wall (oz/CY of concrete or mL/CY of concrete)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

You know the right answer?

The wall designer recommends the use of rounded 3/8-inch nominal maximum aggregate size for this wal...

Questions