Engineering, 06.11.2021 03:50 rocksquad7917

What measures the increase in length relative to the original length stress
strain
tensile strength
compressive strain

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 06.07.2019 02:30

Air (c-1.006 kj/kg.k, r-0.287 kj/kg.k) enters a nozzle steadily at 280 kpa and 77°c with a velocity of 50 m/s and exits at 85 kpa and 320 m/s. the heat losses from the nozzle to the surrounding medium at 20°c are estimated to be 3.2 kj/kg. determine (a) the exit temperature and (b) the total entropy change for this process. solve this problem using constant specific heats.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

You know the right answer?

What measures the increase in length relative to the original length stress
strain
tensi...

Questions