Engineering, 06.11.2021 06:30 nett4386
A deep-drawing operation will take place on aluminum-killed steel with an LDR of 2.5. A cylindrical cup will be produced with a diameter of 75 mm and a sheet thickness of 2 mm. Find: a. The largest permissible blank diameter b. The deepest cup that can be deep drawn
Answers: 3
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
A deep-drawing operation will take place on aluminum-killed steel with an LDR of 2.5. A cylindrical...
History, 28.01.2020 19:57
History, 28.01.2020 19:57
Mathematics, 28.01.2020 19:57
Mathematics, 28.01.2020 19:57
Computers and Technology, 28.01.2020 19:57
History, 28.01.2020 19:57
Mathematics, 28.01.2020 19:57
History, 28.01.2020 19:57
History, 28.01.2020 19:57
Mathematics, 28.01.2020 19:57
World Languages, 28.01.2020 19:57
English, 28.01.2020 19:58