subject
Engineering, 25.11.2021 05:30 quinteroalex2001

What is the resultant phase or phases present in this eutectoid steel after the following heat treatment cycle: First quenched to Ms>T>MF at a cooling rate faster than the critical cooling rate and held for t > 104 sec, followed by reheating to T > 727 o C and held for a long time, and then quenched to Ms < T < TN at a rate faster than the CCR, and held for t > 104 seconds and then quench to room temperature?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
question
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
What is the resultant phase or phases present in this eutectoid steel after the following heat treat...
Questions
question
Mathematics, 27.07.2019 04:00
Questions on the website: 13722361