Engineering, 25.11.2021 06:20 PONBallfordM89

Why does the compression-refrigeration cycle have a high-pressure side and a low-pressure side? a. The pressure difference is the result of polar molecular alignment due to the intense magnetic field created by the compressor motor.

b. So the refrigerant can condense at a low pressure and temperature and evaporate at a high pressure and temperature

c. The pressure difference isn't intentionally created but is simply the result of circulating refrigerant within the compressor.

d. So the refrigerant can evaporate at a low pressure and temperature and condense at a high pressure and temperature

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

You know the right answer?

Why does the compression-refrigeration cycle have a high-pressure side and a low-pressure side? a....

Questions