subject
Engineering, 08.12.2021 17:40 lennyatme

Question 3 of 22 (Refer to Figure 23, area 3.) What is the floor of the Savannah Class C airspace at the shelf
area (outer circle)?
O A. 1,700 feet MSL.
This answer is a distractor and may refer to the maximum elevation figure
(MEF) which is the number 17 shown in blue. The MEF indicates the height of
the highest feature within a quadrangle area and is not associated with the
airspace surrounding Savannah.
OB. 1,300 feet MSL.
Find the large numbers 41/13 in magenta. They indicate the top and the floor of

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 04.07.2019 19:10
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
You know the right answer?
Question 3 of 22 (Refer to Figure 23, area 3.) What is the floor of the Savannah Class C airspace...
Questions
question
Mathematics, 17.10.2020 18:01
question
Mathematics, 17.10.2020 18:01
Questions on the website: 13722363