Engineering, 22.01.2022 02:40 jimmyjimjim
For the diode circuit shown in Figure C1, assume the Turn-On voltage of LED is 2.0V
and LED is 1.4V. Calculate current I, that flows through Resistor Rz
i
If the switch S1 is closed and S2 is open
i. If the switch S2 is closed and S1 is open
in. If both the switches are closed
Answers: 2
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
For the diode circuit shown in Figure C1, assume the Turn-On voltage of LED is 2.0V
and LED is 1.4...
English, 24.09.2021 14:00
Mathematics, 24.09.2021 14:00
Mathematics, 24.09.2021 14:00
Mathematics, 24.09.2021 14:00
English, 24.09.2021 14:00
Biology, 24.09.2021 14:00
History, 24.09.2021 14:00
Biology, 24.09.2021 14:00
Business, 24.09.2021 14:00