Engineering, 22.01.2022 21:40 amychan123
two circular rods of 50mm diameter are connected by a knuckle joint as shown below, by a pin of 40mm in diameter. if a pull of 120KN acts at each end, find the tensile stress in the rod and shear stress in the pin.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
You know the right answer?
two circular rods of 50mm diameter are connected by a knuckle joint as shown below, by a pin of 40mm...
Questions
Mathematics, 15.12.2021 19:30
Health, 15.12.2021 19:30
English, 15.12.2021 19:30
Mathematics, 15.12.2021 19:30
English, 15.12.2021 19:30
English, 15.12.2021 19:30
Mathematics, 15.12.2021 19:30
Mathematics, 15.12.2021 19:30
