Engineering, 25.01.2022 14:00 rebtav
Technician A says that a pilot bearing should always be replaced when a clutch is replaced. Technician B says that oft-dampened clutches ar
better at absorbing torsional vibrations. Who is correct?
O a. Technician A
Answers: 3
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:10
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
Technician A says that a pilot bearing should always be replaced when a clutch is replaced. Technici...
Mathematics, 04.05.2020 22:53
Mathematics, 04.05.2020 22:53
History, 04.05.2020 22:53
Mathematics, 04.05.2020 22:53
Biology, 04.05.2020 22:53
Mathematics, 04.05.2020 22:53
History, 04.05.2020 22:53
Chemistry, 04.05.2020 22:53
Social Studies, 04.05.2020 22:53
Biology, 04.05.2020 22:53
Mathematics, 04.05.2020 22:53
History, 04.05.2020 22:53