subject

Geography, 06.05.2021 03:50 Savagepanda911

In approximately what year did the "scramble for Africa" begin? O A. 1750
O B. 1650
O c. 1880
O D. 1490

ansver

Answers: 1

Show answers

Another question on Geography

question

Geography, 22.06.2019 03:00

Which of these is least likely to be an adaption? a. a mouse digs a hole to hide from predators. b. a snake bites its prey to deliver it deadly venom. c.a jackrabbit has large ears that it release body heat. d.a parrot learns to say its owner's name.

Answers: 1

question

Geography, 23.06.2019 01:00

Which anatomical feature would you expect to find in the fossil remains of a nocturnal species?

Answers: 3

question

Geography, 23.06.2019 09:00

What did the native title act do? a. it recognized and protected aboriginal rights to land. b. it stated that aborigines were to be counted as part of the census. c. it established aboriginal languages as official. d. it granted aborigines suffrage.

Answers: 2

question

Geography, 23.06.2019 16:00

Which phrase describes the time it takes for a planet to make a complete rotation

Answers: 2

You know the right answer?

In approximately what year did the "scramble for Africa" begin? O A. 1750
O B. 1650
O...

Questions

question

Engineering, 11.07.2019 01:10

Which of the following statements about atomic vacancy sites in metals is incznrect a)- a vacancy represents the empty space in an otherwise cosed pac...

question

Engineering, 11.07.2019 01:10

Aheat engine operates between thermal reservoirs of 1000k and 400k. it receives heat at a rate of 200 kw and rejects it at a rate of 90 kw a)- what is...

question

Engineering, 11.07.2019 01:10

In what kind of diffusion processes do we use fick's i and il laws? explain all the parameters (c c(x, t), co, t, and x) shown in the diffusion curve...

question

Engineering, 11.07.2019 01:10

Acapacitance sensor consists of two overlapping plates separated by a small gap filled with either a dielectric material or a vacuum. capacitance is c...

question

Engineering, 11.07.2019 01:10

Across-flow air-to-water heat exchanger (both fluids unmixed) with an effectiveness of 0.65 is used to heat water (cp 4180 j/kg. k) with hot air (c 10...

question

Engineering, 11.07.2019 01:10

Determine the bending stress at the surface of a 3-in.-diameter shaft subjected to a bending moment of 3200 lb-ft....

question

Engineering, 11.07.2019 01:10

Consider a spent nuelear fuel rod of constant thermal conductivity k, perimeter p, length l, and uniform cross-sectional area ac. energy is released a...

question

Engineering, 11.07.2019 01:10

An ideal gas of butane in a piston-cylinder device is initially at 8a fahrenheit and 1 bar undergoes a thermodynamic cycle consisting of three process...

question

Engineering, 11.07.2019 01:10

Calculate the speed of a (i) 0.5-mev electron. ii) 25-mev electron. (b) how much greater than the rest mass is the mass of each of the energetic elect...

question

Engineering, 11.07.2019 01:10

1.0 kg of air at 300 k and 100 kpa (state 1) is slowly compressed in a piston cylinder (closed system). the compression process is an isothermal proce...

question

Engineering, 11.07.2019 01:10

A16-bit aid converter has a full-scale range+10 v. what is the resolution of this a/d in volts? if this a/d were used to measure temperature using a...

question

Engineering, 11.07.2019 01:10

List the different types of solar cells and their efficiency ranges...

question

Engineering, 11.07.2019 01:10

Assuming the following, what is the fill factor for the following solar cell? power=100w voc=30v isc=10a...

question

Engineering, 11.07.2019 01:10

Increasing temperature will reduce the corrosion rate. a)-true b)- false...

question

Engineering, 11.07.2019 01:10

The yield stress of a tension specimen machined from a 2-m wide by 0.6-cm thick copper sheet is 145 mpa. the sheet is rolled further with an applied t...

question

Engineering, 11.07.2019 01:10

Asampling of 409 motor shafts from a very large production batch shows a sample standard deviation in diameter of 0.021 mm with a sample mean of 9.251...

question

Engineering, 11.07.2019 01:10

Explain the aerodynamics of airbus a380 in terms of 1)- l/d 2)- cl max 3)- cd...

question

Engineering, 11.07.2019 01:10

Derive the expression for the thermal efficiency of an air standard bray ton cycle in terms of the pressure ratio and the ratio of specific heats....

question

Engineering, 11.07.2019 01:10

(a) calculate the speed of a 25-mev proton (b) what is the percent increase in mass of this proton over its rest mass?...

question

Engineering, 11.07.2019 01:10

Explain the moire's method and discuss the mismatch techniques of moire's strain analysis with fringe ordering....

More questions: Geography Another questions

Questions on the website: 13722363