Agroup of cats and dogs are going to the vet. each cat weighs an average of 16 pounds, and each dog weighs an average of 35 pounds. they are traveling in a van that can carry a maximum of 8 animals, whose total weight cannot exceed 225 pounds. write a system of inequalities to represent this situation. let c stand for the number of cats and let d stand for the number of dogs.

Step-by-step explanation:

c = cats, d = dogs

c + d < = 8thats less then or equal (because there can be no more then 8 animals in the van ...thats all it can carry

16c + 35d < = 225thats less then or equal (because each 16 lb cat and each 35 lb dog CANNOT have a total weight over 225...it would have to be less or equal to

step-by-step explanation:

if you want to solve percent error follow these steps.

1. subtract the accepted value from the experimental value.

2. take the absolute value of step 1.

3. divide that answer by the accepted value.

4. multiply that answer by 100 and add the % symbol to express the answer as a percentage.

if you want to solve percent of change just do this.

1. work out the difference (increase) between the two numbers you are comparing.

2. divide the increase by the original number and multiply the answer by 100. if your answer is a negative number then this is a percentage decrease.

hope this : )

part a

answer: a reasonable domain is where n is a real number. so n can be between 0 and 10. both endpoints are included.

work shown:

n is the number of days after the experiment starts. the smallest n can be is n = 0 which means that 0 days have gone by, and we're at the start. to find out how large n should be, then replace f(n) with 16.13 and solve for n. use logarithms to isolate the exponent.

f(n) = 12*(1.03)^n

16.13 = 12*(1.03)^n

16.13/12 = (1.03)^n

1.34416666666667 = (1.03)^n

(1.03)^n = 1.34416666666667

log[ (1.03)^n ] = log[ 1.34416666666667 ]

n*log[ 1.03 ] = log[ 1.34416666666667 ]

n = log[ 1.34416666666667 ]/log[ 1.03 ]

n = 10.0062999823929

this rounds to n = 10 which is fairly close but not 100% perfect. so this is the largest n can be.

note: if you plug n = 10 into f(n), you'll get roughly 16.127 which rounds to 16.13 (this comes up again in part c)

=====================================

part b

answer: the y intercept is 12. it represents the starting height of the plant in cm.

work shown:

plug n = 0 into the f(n) function. simplify

f(n) = 12*(1.03)^n

f(0) = 12*(1.03)^0

f(0) = 12*(1)

f(0) = 12

on day n = 0, aka the starting point, the height f(n) is 12 cm

=====================================

part c

answer: the average rate of change is approximately 0.43061036458991 (round however you need to). this represents the average growth rate from day n = 3 to day n = 10. so the plant grew roughly 0.43 cm per day during this timespan, assuming you round to 2 decimal places.

work shown:

compute f(3)

f(n) = 12*(1.03)^n

f(3) = 12*(1.03)^3

f(3) = 13.112724 < we'll use this later

compute f(10)

f(n) = 12*(1.03)^n

f(10) = 12*(1.03)^10

f(10) = 16.1269965521294 < we'll use this later

now use the formula below with a = 3 and b = 10

aroc = average rate of change

aroc = [ f(b) - f(a) ]/[ b - a ]

aroc = [ f(10) - f(3) ]/[ 10 - 3 ]

aroc = (16.1269965521294 - 13.112724)/(10 - 3)

aroc = 3.0142725521294/7

aroc = 0.43061036458991

round this however you need to

note: the plant grew approximately 3.01 cm over 7 days, so roughly 0.43 cm per day is the average growth rate (if you were to round to 2 decimal places).