Mathematics, 05.05.2020 13:56 tabbydory3366
2. A prototype of a part is to be fabricated using stereolithography. The base of the part is shaped like a right triangle with dimensions 36 mm by 48 mm. The height of the part = 30 mm. Layer thickness = 0.15 mm, and laser spot diameter = 0.15 mm. The beam velocity across the surface of the photopolymer = 2200 mm/s. the minimum possible required to build the part, if 25 s are lost each layer to lower the height of the platform that holds the part. Ignore setup time and post processing.
Answers: 1
Mathematics, 21.06.2019 13:00
How can we find the measure of an exterior angle if we know the measurement of an interior angle
Answers: 1
Mathematics, 21.06.2019 15:00
Solve the word problem. the table shows the low outside temperatures for monday, tuesday, and wednesday. by how many degrees did the low temperature increase from monday to tuesday? this function table shows the outside temperature for a given a. 21.1⁰ b. 8.6⁰ c. 4.9⁰ d. 3.9⁰(the picture is the graph the the question is talking about.)
Answers: 1
Mathematics, 21.06.2019 17:30
Kathy spent 5/8 of her money on books and another 1/6 of her money on stationeries.what fraction of kathy’s money was left?
Answers: 2
Mathematics, 21.06.2019 18:00
Sara can take no more than 22 pounds of luggage on a trip.her suitcase weighs 112 ounces.how many more pounds can she pack without going over the limit?
Answers: 1
2. A prototype of a part is to be fabricated using stereolithography. The base of the part is shaped...
Social Studies, 26.09.2019 21:00
Mathematics, 26.09.2019 21:00
Computers and Technology, 26.09.2019 21:00
Mathematics, 26.09.2019 21:00