0. A submarine was at sea level and then dove 752 ft. It then rose at a rate
of 12 ft. per minute. What was the
depth of the submarine after 8
minutes?
Also idk the equation so if u could help me out with that id be grateful

One equation you can use is y = -12x+752 and you plug in x = 8 to find y.

Explanation:

x = number of minutes

y = depth of the submarine

Being at sea level means the depth is y = 0. Diving 752 ft below sea level means the depth is y = 752. It's tempting to make this negative since we're below sea level, but depth values are always positive. They are simply distances you are from the surface of the water. Negative distances are never possible. So this concept might be a bit tricky to get used to.

Possibly equally confusing is the fact that the "12 ft per minute" means the slope is -12. This is because the depth is getting smaller as the submarine gets closer to the surface (aka the sub is rising).

The equation is y = -12x+752. The equation is in the form y = mx+b with m = -12 as the slope and b = 752 as the y intercept. Note how the y intercept is the starting depth value.

From here, we plug in x = 8 to find where the sub is

y = -12x+752

y = -12*8+752

y = -96+752

y = 656

The submarine's depth after eight minutes is 656 feet

An alternative equation to use is

y = 12x-752

which is very similar to the other one used earlier. All I did was flip the sign of each term. Now y represents the height of the sub. Negative y values indicate we're below the surface of the water. The slope being positive means the submarine is going upward. The negative y intercept indicates we're starting 752 feet below sea level. Plugging in x = 8 will lead to y = -656, which you'll need to make positive (since all depth values are positive).

As you can probably guess, the change from y = -12x+752 and y = 12x-752 is simply multiplying the right hand side by -1, which explains why the signs flip (and explains how the y value sign flips as well)

answer is

c) 4

step-by-step explanation:

step-by-step explanation:

ok so im not 100% sure but you would start by adding 5.1t and 1.9t beacuse they have the same variable. that is 7t.   then add -3.6 + 1.2 which is -2.4

so then keep that as -2.4 + 7t. i apologize if this is incorrect. best luck on your test < 3