A manufacturing firm employs three analytical plans for the design and development of a particular product. For cost reasons, all three are used at varying times. In fact, plans 1, 2, and 3 are used for 30%, 20%, and 50% of the products, respectively. The defect rate is different for the three procedures as follows: P(D|P1) = 0.01, P(D|P2) = 0.03, P(D|P3) = 0.02,
where P(D|Pj) is the probability of a defective product, given plan j. If a random product was observed and found to be defective, which plan was most likely used and thus responsible?

to plot points   for x just start at the origin (middle) and go to the left however many times it say(if the number is a positive) if the number is a negative then go right however many times it says if it is 0 go nowhere

now keep you pencil there and go up however many times it says on y(if it is positive) if it is negative then go down however many times it says. if it says 0 go nowhere.

you have just plotted a point! now when you finish plotting all of them connect them with a ruler

plot each point as (-3, 7), (0,4), (3,1), (8,-4)   in the parenthesis on the left of the comma is x and the right is y.

the equation cos(35) =a/25 can be used to find the length of bc what is the length of bc? round to the nearest tenth

step-by-step explanation:

answer: the angel abc is 30°,and the abc is a triangle where the angel bac is 90°

so ac is the half of 24=12ft,and from the pythagorean theorem we find ba

ba=√bc^2-ac^2=√576-144=√432=12√3ft

so bac is 12+12√3=12(1+√3)ft