Physics, 12.07.2019 04:00 NehemiahPate2006

Use the phase diagram above to answer the questions below .( remember that standard pressure is 1.00 atm and it’s used to find normal phase change temperatures.) 1: in which state/phase of matter is this substance at -10 °c and a pressure of 0.50 atm? 2: what phase change occurs as the substance at 0.75 atm is heated from 0°c to 25°c 3: the normal boiling point of a substance is the temperature at standard pressure (1 atm) in which a substance changes from the liquid to the gas/vapor state . what is the normal boiling point of this substance ? 4: the point on the phase diagram where the separation line between liquid and gas ends and the distinction between the liquid phase and gas phase disappears is called the . at this point ,no amount of pressure will cause the substance to condense into a liquid 5: what is the temperature and pressure of the triple point? what phases are in equilibrium at this point ? 6: what phase change occurs as the substance at 0°c has its pressure dropped from 0.50 atm to 0.25 atm?

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 13:40

Niobium forms a substitutional solid solution with vanadium. compute the number of niobium atoms per cubic centimeter for a niobium-vanadium alloy that contains 24 wt% nb and 76 wt% v. the densities of pure niobium and vanadium are 8.57 and 6.10 g/cm3, respectively

Answers: 1

Answer

Physics, 22.06.2019 01:10

Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)

Answers: 3

Answer

Physics, 22.06.2019 01:30

For problems 1-3, consider a simple dc brush motor with a permanent magnet stator. with an an consider a simple dc brush motor with a permanent magnet ae supply voltage of 100 v, the no-load speed of the motor is 1000 rpm. this motor can provide a torque of 1.9 n-m at 800 rpm drawing a current of 2 a current are both zero at no load.) 1. with an armature supply voltage of 100 v, the motor is operated at 900 rpm. what is the motor torque? what is the mechanical power delivered by the motor? what is the current draw? what is the electrical power input? what is the energy efficiency of the motor? with an armature supply voltage of 100 v, the motor is operated at 1100 rpm (where it acts as a generator). what torque input is required? what mechanical power is required what current is generated? what is the electrical power generated? what is the energy efficiency of the motor acting as a generator? 2. with an armature supply voltage raised to 120 v, the motor is operated at 1000 rpm. what is the no-load speed? what is the motor torque? what is the mechanical power delivered by the motor? what is the current draw? what is the electrical power input what is the energy efficiency of the motor? 3.

Answers: 3

Answer

Physics, 22.06.2019 03:10

Aphysical change is a change in the size, shape,, or stafe of matter true or false

Answers: 1

Answer

You know the right answer?

Use the phase diagram above to answer the questions below .( remember that standard pressure is 1.00...

Questions