If a pitch vibrates at 880 cycles, the octave below would vibrate at cycles. 220 440 660 1760

If a pitch vibrates at 880 cycles, the octave below would vibrate at 440 cycles.

Explanation:

Pitch of sound is defined as relative highest and the lowest point of sound. The pitch is dependent on frequency of vibration.

Octave is defined as a tone which is formed due to merging of two different tone. The resultant tone is merged so well that it sound like a single tone.

Thus, Number cycle in octave =

Number cycle in octave =

Number cycle in octave = 440

Thus, If a pitch vibrates at 880 cycles, the octave below would vibrate at 440 cycles.

carbon is found in all living things. carbon atoms move constantly through

living organisms, the oceans, the atmosphere, and the earth’s crust in what is

known as the carbon cycle. the directions taken by carbon atoms through this

cycle are very complicated and can take millions of years to make a full circle.

all animals, from humans to the dinosaurs are part of the carbon cycle. when

animals eat food, they get carbon in the form of carbohydrates and proteins.

in animals, oxygen combines with food in the cells to produce energy for daily

activity and then gives off carbon. the carbon combines with oxygen to form

carbon dioxide (co2) and is released back into the atmosphere as a waste

product when animals breathe and exhale.

from 145-65 million years ago, earth was much

hotter than today and covered with dense,

tropical swamp forests. the trees and other

plants were immense and

provided an endless supply of

food for the giant animals that

roamed the land. somewhere in

the air above one of these

forests, a lone carbon atom has joined

up with two oxygen atoms to form a molecule of co2.

the co2 molecule was sucked into the tiny holes (stomata) on the leaf of a

fern plant and joined with sunlight, chlorophyll and water to make food and

energy in the plant’s cells through photosynthesis. the oxygen (o2) from the

co2 molecule was sent back into the atmosphere; the carbon atom (c) was

detached and used to make a molecule of sugar.

if that carbon atom had been eaten instead, a totally

different situation would have developed. let’s say

that a giant plant-eating dinosaur (herbivore) ate the

fern for breakfast, and swallowed the carbon in the

fern in the form of carbohydrates and proteins. in

the process of respiration, oxygen combined with

the carbohydrates and proteins in the dinosaur’s cells

to provide energy for its daily activity.  

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).