subject
Physics, 24.11.2019 10:31 arely30

What is the difference between creep and a landslide

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 15:30
At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.
Answers: 1
question
Physics, 22.06.2019 20:00
What is the name of the perceived change in a sound wave’s frequency due to motion between the observer and the sound source?
Answers: 1
question
Physics, 22.06.2019 22:00
The inside surface of a cylindrical-shaped cave of inner diameter 1.0 m is continuously covered with a very thin layer of water. the cave is very long and it is open on both ends. the water on the cave surface is at a constant temperature of 15.5 °c. the cave is constantly exposed to wind such that 15.5 °c air flows through the cave at 4.5 m/s. the kinematic viscosity of the air is 14.66 x 10-6 m2/s and the molecular diffusion coefficient of water vapor in the air is 0.239 x 10-4 m2/s. because the cave diameter is so large, the flow of wind down the length of the cave, in the x direction, can be treated like it is external flow and the cave surface can be approximated as flat where appropriate. calculate the x value, in a) the transition to turbulent flow occurs at rex meters, where the air flow transitions from laminar to turbulent along the inside surface of the cave b) calculate the x value, in meters, where the bulk steady state concentration of water vapor in the air flowing in the cave is 10% of the saturation concentration. assume the air at the surface of the water layer is 100% saturated with water vapor. assume the wind entering the cave contained no moisture before it entered the cave. take into account the transition from laminar to turbulent flow when solving part b
Answers: 1
question
Physics, 23.06.2019 02:30
Ball bearings are made by letting spherical drops of molten metal fall inside a talll tower-called a shot tower- and solidify as they fall. a-if a bearing needs 4.0 s to solidify enough for impact, how high must the tower be? b- what is the bearing's impact velocity?
Answers: 3
You know the right answer?
What is the difference between creep and a landslide...
Questions
question
Mathematics, 20.09.2019 16:10
Questions on the website: 13722367