A500n person stands 2.5m from a wall against which a horizontal beam is attached. the beam is 6m long and weighs 200n. a cable is attached to the free end of the beam and makes an angle of 45 to the horizontal and is attached to the wall.
1)determine the magnitude of the tension of the cable.
2)determine the reaction force that the wall exerts on the beam.

In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?

The rocket is fired vertically and tracked by the radar station shown. when θ reaches 66°, other corresponding measurements give the values r = 32700 ft, r¨ = 85 ft/sec2, and θ˙ = 0.019 rad/sec. calculate the magnitudes of the velocity and acceleration of the rocket at this position.

Awater-filled u-tube manometer is used to measure the pressure inside a tank that contains air. the water level in the u-tube on the side that connects to the tank is 5 ft above the base of the tank. the water level in the other side of the u-tube (which is open to the atmosphere) is 2 ft above the base. determine the pressure within the tank.