Consider an a-36 steel (g= 11,000 ksi) shaft made of two solid parts (ab and cd) and one tubular(hollow) part (bc). the solid parts both have a diameter of 10 in. and the tubular part has an outerdiameter of 8 in. and an inner diameter of 7 in. the shaft is supported at both ends by bearings (aand d) such that it can rotate freely, and it is subjected to 40 lb-ft and 40 lb-ft torques as shown infigure. determine the angle of twist of gear b relative to gear c.

Momentum lab this lab uses a phet simulation. navigate to the phet momentum simulation. if you don’t see the image below when you click on the link, then you need to either enable adobe flash (click on the puzzle piece on your screen) or you need to install adobe flash (this is a free program). change the vectors to be momentum vectors only. they are yellow. make the mass of both balls the same. hit play and notice what happens to the momentum vectors before and after the collision. you might want to play the sim multiple times. click on restart or return balls to start over. to see numbers, check the show values box (inside the green box). red’s momentum vector before the collision is green’s momentum vector after the collision. question 1 options: shorter than longer than equal to question 2 (1 point) saved since green bounces off red, this must be an collision. question 2 options: explosion inelastic elastic question 3 (1 point) red transfers of its momentum to green during the collision. question 3 options: little all most none question 4 (4 points) why does red transfer all its momentum to green? back up your answer with information from the simulation. write at least 2 sentences.