subject
Physics, 01.07.2019 21:40 najsha

Arigid bar eh is supported by two steel wire of 1/16 in diameter (e=29 106psi) and a pin and bracket at h. knowing that the wires were initially tight. determine (a) the additional tension in each wire when a 200-lb load p is applied at e. (b) the corresponding deflection (downward displacement) of point e.

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 01:10
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
question
Physics, 22.06.2019 01:20
Your target variable is δf, the magnitude of the difference in frequency between the waves emitted from the sonar device and the waves received by the device after reflecting off the whale. write an expression for δf in terms of the relevant frequencies using the subscript notation introduced above.
Answers: 3
question
Physics, 22.06.2019 02:40
What happens when chlorine reacts with bromine? a. electrons move from the chlorine atoms to the bromine atoms. b. electrons move from the bromine atoms to the chlorine atoms. c. electrons are shared between the chlorine atoms and the bromine atoms. d. electrons become delocalized among the atoms.
Answers: 2
question
Physics, 22.06.2019 12:30
When a vertical beam of light passes through a transparent medium, the rate at which its intensity i decreases is proportional to i(t), where t represents the thickness of the medium (in feet). in clear seawater, the intensity 3 feet below the surface is 25% of the initial intensity i0 of the incident beam. what is the intensity of the beam "10" feet below the surface? (give your answer in terms of i0. round any constants or coefficients to five decimal places.)
Answers: 2
You know the right answer?
Arigid bar eh is supported by two steel wire of 1/16 in diameter (e=29 106psi) and a pin and bracke...
Questions
Questions on the website: 13722367