Back of the envelope in addition to solving the problems below, discuss the typical values and/or ranges for the parameters you will need? (a) how long does it take a thermal perturbation at the base of a craton to reach the sur face? consider what you will need to know to solve this problem (b) the retreat of glaciers at the end of the pleistocene (~10 ka) allowed warmer air tem- peratures to heat the ground. how deep a borehole would we need to observe temper atures undisturbed by warming? assume a diffusivity of 0.8x 10-6 m2 s-1.

Mass (kg) force (n) 5 25 10 50 15 75 20 100 a student was trying to find the relationship between mass and force. he placed four different masses on a table and pulled them using a spring scale. the table shows the different masses used in the experiment and the force required to pull each mass. the student concluded that more force was required to pull heavier objects. what comment would you make regarding his conclusion? a) no clear relation can be observed between mass and force from the data. b) there is a direct proportion between the mass and force listed in the table. c) gravity should have been taken into account while performing the experiment. d) there is an inverse proportion between the mass and force listed in the table.

Automobile fuel efficiency is often measured in miles that the car can be driven per gallon of fuel (mpg). heavier cars tend to have lower fuel efficiencies (lower mpg ratings). which variable (weight or fuel efficiency) is most naturally considered the explanatory (predictor) variable in this context?

Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.