Physics, 03.07.2019 02:30 catwomn

Asteel bar has cross-sectional area a=10-3 m2, young modulus e= 2 x 1011 pa and poisson’s ratio of 0.4. the steel bar has a rectangular cross sectional area.
a. if the bar is subject to a compressive force of 105 n, find the corresponding longitudinal and transverse strains. [3 marks]
b. two strain gauges, each with unstrained resistance of 120 ω and a gauge factor of 2.0 are bonded on to the top surface of the steel bar.
determine the corresponding gauge resistance for the longitudinal and transverse strains. [4 marks]
c. draw a diagram that show how the strain gauges are placed on the bar and to which resistor location of the wheatstone bridge is each of them connected.
assuming that you have another two additional strain gauges with the same specifications, how would you place these additional strain gauges and draw the set-up of the 4 strain gauges together with the wheatstone bridge. [3 marks]

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 19:00

How many neutrons does element x have if it’s stormy umber is 33 and it’s mass number is 95?

Answers: 3

Answer

Physics, 22.06.2019 06:00

Suppose water is leaking from a tank through a circular hole of area ah at its bottom. when water leaks through a hole, friction and contraction of the stream near the hole reduce the volume of water leaving the tank per second to cah 2gh , where c (0 < c < 1) is an empirical constant. a tank in the form of a right-circular cone standing on end, vertex down, is leaking water through a circular hole in its bottom. (assume the removed apex of the cone is of negligible height and volume.) (a) suppose the tank is 20 feet high and has radius 8 feet and the circular hole has radius 2 inches. the differential equation governing the height h in feet of water leaking from a tank after t seconds is dh dt = − 5 6h3/2 . if the height of the water is initially 8 feet, how long will it take the tank to empty? (round your answer to two decimal places.)

Answers: 2

Answer

Physics, 22.06.2019 11:00

A2.00-m long piano wire with a mass per unit length of 12.0 g/m is under a tension of 8.00 kn. what is the frequency of the fundamental mode of vibration of this wire?

Answers: 3

Answer

Physics, 22.06.2019 11:50

The scalar triple product computes the magnitude m of the moment of a force vector f about a specified line. it is m = (r × f) · n, where r is the position vector from the line to the point of application of the force and n is a unit vector in the direction of the line. use matlab to compute the magnitude m for the case where f = [12, −5, 4] n, r = [−3, 5, 2] m, and n = [6, 5, −7].

Answers: 3

Answer

You know the right answer?

Asteel bar has cross-sectional area a=10-3 m2, young modulus e= 2 x 1011 pa and poisson’s ratio of 0...

Questions