subject
Physics, 05.07.2019 03:20 thelongneckkid

A1.6 g plastic bead charged to -3.2 nc and a 3.6 g glass bead charged to 17.0 nc are 2.1 cm apart (center to center). (part a) : what are the magnitudes of the accelerations of the plastic bead and the glass bead?
express your answers using two significant figures. enter your answers numerically separated by a comma. (part b) : what are the directions of the accelerations of the plastic bead and the glass bead?
a) the beads accelerate away from each other. b) the beads accelerate toward each other.
c) the beads accelerate in the same direction.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 20:20
Suppose that a comet that was seen in 563 a.d. by chinese astronomers was spotted again in year 1951. assume the time between observations is the period of the comet and take its eccentricity as 0.986. what are (a) the semimajor axis of the comet's orbit and (b) its greatest distance from the sun?
Answers: 1
question
Physics, 22.06.2019 14:00
Agraduated cylinder contains 63.0 ml of water. a piece of gold, which has a density of 19.3 g/ cm3, is added to the water and the volume goes up to 64.5 ml. calculate the mass in grams of the gold that was added to the water. explain how you got your answer.
Answers: 3
question
Physics, 22.06.2019 21:30
Ineed this now one scientist feels that the changes in global climatic patterns may be good for the health of the biosphere. another scientist feels that sharp changes in climatic patterns could result in the extinction of the biosphere. which of these is the most likely reason the two scientists gave conflicting opinions on the impact of changes in the global climatic pattern? they do not have enough knowledge on the topic. they did not discuss the issue among themselves. they believe conflicting opinion strengthens science. they study different areas of science and have different scientific focuses.
Answers: 1
question
Physics, 22.06.2019 21:40
Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.
Answers: 1
You know the right answer?
A1.6 g plastic bead charged to -3.2 nc and a 3.6 g glass bead charged to 17.0 nc are 2.1 cm apart (c...
Questions
Questions on the website: 13722361