subject
Physics, 10.07.2019 19:20 Stevencriollo6838

In this problem we will make use of the fact that for closed orbits the latus rectum a of the orbit is equal to a gm where g is the universal gravitational constant, / is the angular momentum per unit mass of the orbiting body, and mis the (much larger) mass of the body at one focus of the orbit the following questions refer to the shuttlecraft orbit shown in problem 1 above use your knowledge of kepler's laws and your results in problem 1 to determine expressions for (i) the shuttle's speed vp at perigee, and (ii the shuttle's speed va at apogee. write each expression in terms of g, m e, and the corresponding distance (rp or ra) a. b. use your results from part a of this problem to calculate the quantities listed below. in your work, assume that the planet has approximately the same radius and mass as earth (ie., rplanet re 6.38 x 10° m, and gms gme 3.98 x 10 n-m-/kg). in addition, suppose that the orbit of the shuttle has perigee rp = 2re and apogee ra = 8re. 14 = = i. the eccentricity e of the original (elliptical) orbit ii. the latus rectum a of the orbit iii. the speed vp at perigee in the orbit iv. the speed va at apogee in the orbit the minimum speed your shuttlecraft must attain at point p (e. g., by quickly firing your thrusters as you pass that point) in order to leave the planet v. (hint: what minimum value of eccentricity e is required for the shuttle's orbit in this case? )

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 23:30
Part a determine the magnitude of the x component of f using scalar notation. fx f x = nothing lb request answer part b determine the magnitude of the y component of f using scalar notation. fy f y = nothing lb request answer part c determine the magnitude of the z component of f using scalar notation. fz f z = nothing lb request answer provide feedback figure1 of 1a force vector acting on a ring attached to the ground is shown in the xyz space together with its x, y, and z components lying on the corresponding positive axes. the ring is located at the origin. force f is located in the first octant. f makes an angle of 60 degrees with its x component and an angle of 45 degrees with its y component. a force vector acting on a ring attached to the ground is shown in the xyz space together with its x, y, and z components lying on the corresponding positive axes. the ring is located at the origin. force f is located in the first octant. f makes an angle of 60 degrees with its x component and an angle of 45 degrees with its y component.
Answers: 2
question
Physics, 22.06.2019 05:30
Agas expands from an initial volume of 0.040 m^3 and an initial pressure of 210 kpa to a final volume of 0.065 m^3 while its temperature is kept constant. how much work is done by the system?
Answers: 1
question
Physics, 22.06.2019 06:00
A1,700kg car is being used to give a 1,400kg car a push start by exerting a force of 140n the impulse on the smaller car during the 30.0s of contact is +670kg*m/s. what is the impulse of the smaller car on the larger car? -814 kg*m/s 0kg *m/s -670kg*m/s -550kg*m/s
Answers: 1
question
Physics, 22.06.2019 08:00
Tafari worked one summer on a ship that set weather buoys in the ocean. he watched how one of the buoys moved in the water. describe which parts of the wave would cause the buoy to bob up and down. which wave property determined how fast the buoys bobbed in the water? he observed that when the wind blew harder, the ocean waves were larger, and the buoys moved away from the ship. what effect, if any, did the waves have on how far the buoys moved? explain your answer.
Answers: 3
You know the right answer?
In this problem we will make use of the fact that for closed orbits the latus rectum a of the orbit...
Questions
question
Mathematics, 15.04.2021 20:30
question
Physics, 15.04.2021 20:30
question
Mathematics, 15.04.2021 20:30
Questions on the website: 13722360