State the equipartition theorem and use it to calculate the molar heat capacity in an isochoric process for: (i) a monoatomic gas; (ii) a diatomic gas. • state the relation between c, and cy for an ideal gas and use it to calculate the molar heat capacity in an isobaric process for: (i) a monoatomic gas; (ii) a diatomic gas. • consider an ideal gas which contains » moles of the monoatomic molecules and v moles of the diatomic molecules. (i) derive the molar heat capacity for the gas mixture in an isochoric process. (ii) derive the molar heat capacity for the gas mixture in an isobaric process. (iii) based on these calculations, derive the adiabatic coefficient. • consider a classroom where the air is at a temperature of 20°c and pressure of 1 atm. (i) using the equation of state for an ideal gas, estimate the average distance between air molecules in the classroom. (ii) using the random walk model for molecules, estimate the mean free path of air molecules in the classroom.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

the cellphone, they would then know if the killer would have contacted them or always hated them. or if it was a breakup. but if that is not the case, then it would be the clothing. to put in a bullet, it would have to be put in by hands. hands have finger prints which, would have giving you the answer of who done it.

explanation:

multiple