subject
Physics, 25.09.2019 19:30 asiaboo0

Astrand of 10 lights is plugged into an outlet. how can you determine if the lights are connected in series or parallel? a) unscrew one light. if the other lights stay on, it's a series circuit. b) unplug the strand. if the first light stays on, it's a series circuit. c) unscrew one light. if the other lights turn off, it's a series circuit. d) cut the strand in half. if the plugged in half stays on, it's a series circuit

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 12:30
What law energy has never been broken
Answers: 1
question
Physics, 22.06.2019 00:00
1134567 a jet with mass m = 1.1 ă— 105 kg jet accelerates down the runway for takeoff at 2 m/s2. 1) what is the net horizontal force on the airplane as it accelerates for takeoff? 2.2*10^5 n your submissions: 2.2*10^5 computed value: 220000submitted: saturday, january 26 at 2: 41 pm feedback: correct! 2) what is the net vertical force on the airplane as it accelerates for takeoff? 0 n your submissions: 0 computed value: 0submitted: saturday, january 26 at 2: 41 pm feedback: correct! 3) once off the ground, the plane climbs upward for 20 seconds. during this time, the vertical speed increases from zero to 21 m/s, while the horizontal speed increases from 80 m/s to 95 m/s. what is the net horizontal force on the airplane as it climbs upward? n 4) what is the net vertical force on the airplane as it climbs upward? n 5) after reaching cruising altitude, the plane levels off, keeping the horizontal speed constant, but smoothly reducing the vertical speed to zero, in 13 seconds. what is the net horizontal force on the airplane as it levels off? n 6) what is the net vertical force on the airplane as it levels off?
Answers: 1
question
Physics, 22.06.2019 12:00
You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 2.70 miss . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?
Answers: 2
question
Physics, 22.06.2019 15:00
10 points! will mark brainiest! in a heat engine if 1,000 j of heat enters the system and the piston does 500 j of work, what is the final internal energy of the system if the initial energy was 2,000 j 1: write the equation2: list out your known variables 3: plug the numbers into the equations 4: solve 5: write your solution statement that includes initial energy and final energy added you so much!
Answers: 2
You know the right answer?
Astrand of 10 lights is plugged into an outlet. how can you determine if the lights are connected in...
Questions
question
Computers and Technology, 02.04.2020 20:02
Questions on the website: 13722360